200W Power SWR Meter
200W Power SWR Meter
Description:
Specifications:
• Frequency Range: 1.6-50MHz
• Power Measurement Range: 0.5W-200W
• Standing Wave Measurement Range: 1.0-99.9
• Insertion Loss: < 0.12dB
• Standing Wave Insertion: ≤ 1.02 at 1.6-30MHz; ≤ 1.05 at 30-50MHz
• Measurement Accuracy: Better than ±5%
• Impedance: 50Ω
• RF Interface Type: SO239
• Display Type: 1.29-inch OLED Screen
• Power Supply: Built-in rechargeable lithium battery or USB type-C
• Power Consumption: < 0.1uA
• Dimensions: 88 x 38 x 64mm / 3.5 x 1.5 x 2.5 inches (excluding protrusions)
Features:
• Digital Power Standing Wave Meter: Measures HF shortwave power up to 200W.
• Upgraded Hardware: Includes a 1.29-inch large OLED display screen.
• Improved Firmware: New fitting algorithm and multi-point correction algorithm enhance accuracy and functionality.
• Display Modes: Normal mode and peak hold mode, with dynamic analog display bar for intuitive power status under SSB.
• High Accuracy: Accuracy better than 5% over the entire power range of 0.5W to 200W.
• Multiple Interfaces: 5 display methods with high-speed average detection mode and real-time efficiency display.
• Standing Wave Alarm: Intermittent beep alarm for standing wave ≥ 2.0, continuous beep alarm for standing wave ≥ 3.0. The alarm can be turned off.
• Built-in Lithium Battery: Provides more than 50 hours of use on a single charge.
• Multi-Function Button: Enhances usability and interaction for future functions.
• Firmware Upgrade: Supports upgrades via USB type-C.
Package Includes:
• 1 x Power SWR Meter
Usage Instructions:
• Power On/Off: Long press the switch to turn on/off.
• Display Interface: Short press the button to switch display interfaces. Double click to switch the standing wave alarm. Triple click to switch between normal mode and peak hold mode.
• Charging Indicator: Red light indicates charging, and the light goes out when fully charged.
Attention:
• The above parameters are measured by professional instruments and are accurate. Continuous use at 200W detection is supported, but exceeding 500W can damage detection components.
View full details